Back to Learning Center
Applications

Through-Deck Welding: Gun Setups, Deck Profiles & Common Mistakes

9 min readOctober 2024

Through-deck composite slab work is one of the most demanding and quality-sensitive stud welding applications in structural steel construction. Getting it right requires the correct gun setup, ferrule selection, and parameter adjustments for the specific deck profile. Here's everything you need to know.

What Is Through-Deck Welding?

Through-deck welding installs headed shear studs directly through corrugated metal deck onto the steel beam below — without pre-punching holes. The arc burns through the deck and fuses to the beam flange, creating a composite connection for the slab above.

Deck Profile Matters

Different deck profiles (1.5", 2", 3") require different gun extensions and ferrule sizes. The stud must extend at least 1.5" above the top of the deck ribs per AWS D1.1. Make sure your stud length accounts for the deck height plus the required embedment.

Ferrule Selection

Through-deck ferrules have a wider base that rests on the deck surface, centering the stud over the rib valley. Never use flat (downhand) ferrules for through-deck work — they won't seat properly and will blow flash under the deck.

Parameter Adjustments

Through-deck welding requires increased weld time and amperage compared to welding directly to bare steel. The arc must burn through the deck material before reaching the beam flange. Typical increase is 15–25% over bare steel parameters. Always bend test 10 studs at the start of each setup.

Common Mistakes

  • Using flat ferrules instead of through-deck ferrules
  • Insufficient stud length — stud doesn't extend 1.5" above deck ribs
  • Not increasing parameters for the extra burn-through requirement
  • Welding in rib valleys instead of over the top flange of the beam
  • Skipping bend tests after parameter or deck profile changes
  • Working in wet conditions without drying the deck surface first

Inspection

AWS D1.1 requires visual inspection of all through-deck studs plus bend testing per the approved inspection frequency. A sound through-deck weld will have a full 360° flash ring visible above the deck surface. Missing or irregular flash is a red flag.

Ready to Rent?

Put This Knowledge to Work

Every machine we rent is pre-calibrated to your stud specs before it ships. Get an exact quote for your next job.