Back to Learning Center
Process

CD vs. Arc Stud Welding

5 min readMay 2026

There are two main types of stud welding used in construction, fabrication, manufacturing, and field repair: capacitor discharge stud welding (CD stud welding) and drawn arc stud welding (arc stud welding). Both processes weld a stud or fastener directly to a base material. The difference is the amount of weld energy, the size of the fastener, the base material thickness, and the type of application.

Quick Answer

Use CD stud welding for: small studs, pins, insulation fasteners, signs, sheet metal, stainless panels, aluminum panels, thin material, and clean one-sided attachments.

Use arc stud welding for: headed shear studs, deformed bar anchors, larger threaded studs, structural steel, bridges, metal deck, embed plates, refinery work, and heavier base materials.

CD Stud Welding

CD stud welding uses stored electrical energy from capacitors. When the trigger is pulled, the energy discharges very quickly through the stud. The weld happens in milliseconds. Because the weld cycle is extremely fast, CD welding is commonly used on thinner materials where appearance and low heat input matter.

Common CD Applications

  • Sheet metal
  • Signs and architectural panels
  • Insulation pins
  • Cup head pins
  • Electrical enclosures
  • Stainless steel panels
  • Aluminum panels
  • Food service equipment
  • HVAC work
  • Light manufacturing

Arc Stud Welding

Arc stud welding uses a controlled arc to melt the end of the stud and the base metal. The stud welding gun lifts the stud, creates an arc, holds the arc for the set time, and then plunges the stud into the molten weld pool. For many arc applications, a ceramic ferrule is used to contain the molten metal and shape the weld flash around the stud.

Common Arc Applications

  • Headed shear connector studs
  • Composite metal deck
  • Bridge girders
  • Deformed bar anchors
  • Embed plates
  • Wood nailer threaded studs
  • Refineries
  • Industrial steel
  • Heavy fabrication
  • Structural steel connections

Process Selection Chart

  • Thin sheet metal → CD
  • Small threaded studs → CD
  • Insulation pins → CD
  • Signs and panels → CD
  • 1/2 inch and larger structural studs → Arc
  • Headed shear studs → Arc
  • Deformed bar anchors → Arc
  • Bridge girders → Arc
  • Metal deck / high-rise work → Arc
  • Embed plates → Arc
  • Refinery steel work → Arc

Still not sure? A good starting point: if the fastener is small and the base material is thin, look at CD welding. If the fastener is structural or the base material is heavy steel, look at arc stud welding.

Ready to Rent?

Put This Knowledge to Work

Every machine we rent is pre-calibrated to your stud specs before it ships. Get an exact quote for your next job.